This chapter explains how to operate the various controls necessary for driving.
Mainshaft Assembly Clearance Inspection (M/T)
NOTE: If replacement is required, always replace the synchro sleeve and the
synchro hub as a set.
Support the bearing inner race with an appropriate size socket (A), and
push down on the m ...
TPMS System Description (USA models)
TPMS Control Unit Inputs and Outputs at the
20P Connector
@font-face{font-family:
"Honda_SymbolMarkeng";src:url(/statics/ho_prod_2/txt/Honda_SymbolM ...
Transmission End Cover ATF Feed Pipe Replacement (A/T)
Remove the snap ring (A), the 3rd clutch feed pipe (B), and the feed pipe
flange (C) from the end cover (D).
Install a new O-ring (E) over the 3rd clutch feed pipe.
In ...