This chapter describes the buttons, indicators, and gauges that are used while driving.
Removal
Raise and support the vehicle.
Remove the rear wheel.
Remove the wire guide grommet (A) from both sides of the axle beam.
@font-face ...
Countershaft Inspection (M/T)
Inspect the gear and bearing contact areas for wear and damage, then
measure the countershaft at points A, B, and C. If any part of the
countershaft is less than the service limit, replace ...
Clutch Pedal Position Switch Replacement (With Cruise Control (M/T))
Disconnect the 2P connector (A) from the clutch pedal position switch
(B).
@font-face{font-family:
"Honda_SymbolMarkeng"; ...