Clutch Wave-Plate Phase Difference Inspection (A/T)
Place the clutch wave-plate (A) on a surface plate, and set a dial
indicator (B) on the wave-plate.
Find the bottom (C) of a phase difference of the wave-plate, zero the
di ...
Vents, Heating, and A/C
* : If equipped
Airflow Controls
Fan Control Dia
Turn this dial to increase or decrease the fan speed and airflow.
Temperature Control Dial
Turning this dial clockwise increases the temperature ...
Countershaft Inspection (M/T)
Inspect the gear and bearing contact areas for wear and damage, then
measure the countershaft at points A, B, and C. If any part of the
countershaft is less than the service limit, replace ...