Honda Fit: Tools

See also:

Rectifier Test
Check for continuity in each direction, between the B terminal and P terminals, and between the E terminal and P terminals of each diode pair. All diodes should have continuity in only one ...

Cylinder Head Installation
Clean the cylinder head and the engine block surface. Install a new coolant separator (A) in the engine block whenever the engine block is replaced. Install a new ...

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...