Honda Fit: Output Shaft (Countershaft) Speed Sensor Replacement (M/T)
M/T
-
Raise the vehicle on a lift.
-
Disconnect the output shaft (countershaft) speed sensor connector (A).
-
Remove the output shaft (countershaft) speed sensor (B).
-
Install the parts in the reverse order of removal with a new O-ring (C).
See also:
Carbon Monoxide Hazard
Your vehicle’s exhaust contains carbon monoxide gas. Carbon monoxide should not
enter the vehicle in normal driving if you maintain your vehicle properly and follow
the information on this page. ...
Cylinder Head Installation
Clean the cylinder head and the engine block surface.
Install a new coolant separator (A) in the engine block whenever the
engine block is replaced.
Install a new ...
Fuses
The vehicle’s fuses are contained in three fuse boxes.
The interior fuse box is behind the driver’s coin tray. To access it, remove
the tray by turning the dial counterclockwise then pulling ...
Categories
