Open the glove box. Remove the glove box stop on each side, then let the glove box hang down.
Pull the dust and pollen filter assembly (A) out from the blower unit.
Remove the filter (A) from the housing (B), and replace the filter.
Install the filter in the reverse order of removal. Make sure that there is no air leaking out of the blower unit.
Driver's Seat Position Sensor Replacement
Removal
NOTE: Do not turn the ignition switch to ON (II), and do not connect the
battery cable while removing the driver's seat position sensor.
Do the battery terminal disconnection ...
Mainshaft Reassembly (M/T)
Exploded View
Special Tools Required
Driver Handle, 40 mm I.D. 07746-0030100
Bearing Driver Attachment, 30 mm I.D. 07746-0030300
NOTE: Refer to the Exploded Viewas neededduring this proc ...
Rocker Arm and Shaft Inspection
Remove the rocker arm assembly.
Disassemble the rocker arm assembly.
Measure the diameter of the shaft at the first rocker location.
Zero the gaug ...