Honda Fit manuals

Honda Fit: Alternator Disassembly (Page -3)

  1. Install a new front bearing in the drive-end housing with a hammer, the driver handle, 15 x 135L (A), and the bearing driver attachment, 42 x 47 mm (B).

  2. A07749-0010000B07746-0010300
  1. Remove the stator (A).

  2. A
  1. Remove the terminal insulator (A) and the harness bracket (B).

  2. BA
  1. Remove the voltage regulator/brush holder assembly (A) and the rectifier (B).

  2. AB
See also:

Lift and Support Points
NOTE: If you are going to remove heavy components such as suspension or the fuel tank from the rear of the vehicle, first support the front of the vehicle with tall safety stands. When substantial ...

Fuse Locations
INTERIOR FUSE BOX UNDER-HOOD FUSE BOXES Primary Fuse Box Secondary Fuse Box (On the battery) ...

What to Do If
The ignition switch does not turn from to . Why? ● The steering wheel may be locked. ● Try to turn the steering wheel left and right while turning the ignition key. The i ...

© 2026 Copyright www.hfitinfo.com