Honda Fit: Charging / Alternator / Generator

See also:

EPS Control Unit Removal/Installation
Do the battery terminal disconnection procedure. Remove the under-dash fuse/relay box. Disconnect EPS control unit connector A (11P) and connector B (16P) by pus ...

Installation
Install the damper rubber mount (A) onto the damper unit. Position the damper assembly (B) between the body and the axle beam. NOTE: Be careful not to damage the body. ...

Alternator Brush Inspection
Measure the length of both brushes (A) with a vernier caliper: If either brush is shorter than the service limit, replace the brushes, go to step 20. If brush length ...