Honda Fit: Electrical

See also:

Driveshaft Removal
Special Tools Required Ball Joint Remover, 28 mm 07MAC-SL0A202 Ball Joint Thread Protector, 14 mm 071AF-S3VA000 Raise and support the vehicle. Remove the front wheel. ...

A/T Housing Reverse Idler Gear Installation (A/T)
Lightly coat the reverse idler gear shaft (A), the needle bearing (B), and new O-rings (C) with lithium grease. Assemble the new O-rings and the needle bearing on the reverse ...

Removal
Raise and support the vehicle. Remove the rear wheel. Remove the wire guide grommet (A) from both sides of the axle beam. @font-face ...