Honda Fit: Brake Control and Vehicle Dynamics

See also:

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Piston Installation
If the Crankshaft is Already Installed Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed. Remove the connecting rod caps, and check that ...

A/T Secondary Shaft Sealing Ring Replacement (A/T)
The sealing rings are synthetic resin with chamfered ends. Check the condition of the sealing rings, and replace them only if they are worn, distorted, or damaged. For a better fit, squeeze ...