Honda Fit: Wheel Speed Sensor Replacement
Front
-
Turn the ignition switch to LOCK (0).
-
Remove the grommet (A), then disconnect the wheel speed sensor connector (B).
-
Remove the bracket (C), the clip (D), and the wire guide rubber (E).
-
Remove the bolt and the wheel speed sensor (F).
-
Install the wheel speed sensor in the reverse order of removal, and note these items:
-
Do not twist the sensor wires.
-
If the wheel speed sensor comes in contact with the wheel bearing, it is faulty.
-
Make sure the grommet is installed properly.
-
Make sure there is no debris in the sensor mounting hole.
-
Rear
-
Turn the ignition switch to LOCK (0).
-
Pull back the carpet under the rear seat, then disconnect the wheel speed sensor connector (A).
-
Remove the grommet (B), the bracket (C), the clips (D), and the wire guide rubber (E).
-
Remove the bolt and the wheel speed sensor (F).
-
Install the wheel speed sensor in the reverse order of removal, and note these items:
-
Do not twist the sensor wires.
-
If the wheel speed sensor comes in contact with the hub bearing unit, it is faulty.
-
Make sure the grommet is installed properly.
-
Make sure there is no debris in the sensor mounting hole.
-
See also:
Using Speed Dial
PHONE button
► Speed Dial 1 or Speed Dial 2
1. Select a speed dial entry.
2. Select Call to begin dialing.
To make a call using speed dial, you need to
create speed dial entries.
More S ...
Address Calculation
The destination icon shows only the
approximate location of a destination
address. This occurs if the number of
possible addresses is different from the
number of actual addresses on a block. For
...
Recirculation Control Cable Adjustment
Open the glove box. Release the glove box stop on each side, then
let the glove box hang down.
Set the recirculation control lever to FRESH ().
Detach the recirculation ...
Categories
