Countershaft Inspection (M/T)
Inspect the gear and bearing contact areas for wear and damage, then
measure the countershaft at points A, B, and C. If any part of the
countershaft is less than the service limit, replace ...
Power Windows
Turn the ignition switch to the ON (II) position to raise or lower any window.
To open the window, push the switch down and hold it. Release the switch when you
want to stop the window. To close ...
Servo Body Disassembly, Inspection, and Reassembly (A/T)
Clean all parts thoroughly in solvent, and dry them with compressed air.
Blow out all passages.
Inspect the servo body for scoring and damage.
Check all valves for fre ...