Honda Fit: Steering Angle Sensor Replacement
SRS components are located in this area. Review the SRS component locations and the precautions and procedures.
NOTE: Do not damage or drop the combination switch as the steering angle sensor is sensitive to shock and vibration.
-
With the wheels in the straight ahead position and the steering wheel centered, remove the steering wheel.
-
Remove the steering column covers and the cable reel.
-
Remove the combination switch assembly.
-
Remove the combination light switch (A) and the wiper/washer switch (B) from the combination switch body assembly (C).
-
Install the combination switch body assembly in the reverse order of removal.
NOTE:
-
Do not remove the steering angle sensor from the combination switch body.
-
When installing the cable reel, set the turn signal canceling sleeve position so that the arrow points straight up.
-
Tighten the combination switch assembly/cable reel mounting screw in the proper sequence.
-
See also:
Route Commands
The system accepts these commands
when a route is set.
How long to the destination?
How far to the destination?
Display destination map
Display entire route ...
Other Features
This section describes the useful functions incorporated into the
navigation system. ...
Output Shaft (Countershaft) Speed Sensor Replacement (A/T)
Remove the air cleaner assembly.
Disconnect the output shaft (countershaft) speed sensor connector, and
remove the output shaft (countershaft) speed sensor (A).
...
Categories
