Synchro Sleeve and Hub Inspection and Reassembly (M/T)
Inspect gear teeth on all synchro hubs and the synchro sleeves for
rounded off corners, which indicate wear.
Install each synchro hub (A) in its mating synchro sleeve (B), and che ...
EPS Control Unit Removal/Installation
Do the battery terminal disconnection procedure.
Remove the under-dash fuse/relay box.
Disconnect EPS control unit connector A (11P) and connector B (16P) by
pus ...
Steering Angle Sensor Replacement
SRS components are located in this area. Review the
SRS component locations and the
precautions and procedures.
NOTE: Do not damage or drop the combination switch as the steering angle ...