Honda Fit: Recirculation Control Cable Adjustment
-
Open the glove box. Release the glove box stop on each side, then let the glove box hang down.
-
Set the recirculation control lever to FRESH ().
-
Detach the recirculation control cable housing from the clamp (A), and disconnect the inner cable (B) from the recirculation control linkage (C).
-
Turn the recirculation control linkage fully clockwise, and hold it. Attach the recirculation control cable to the recirculation control linkage, then install the recirculation control cable housing into the clamp.
-
If the recirculation control cable can't be adjusted to work properly, replace the cable:
-
Detach the cable from the recirculation control linkage.
-
Detach the cable from the recirculation control lever, and remove it.
-
Install the new cable in the reverse order of removal, then adjust the cable.
-
-
After installation, operate the controls to make sure they work properly.
See also:
Camshaft Inspection
Remove the camshaft sprocket.
Remove the rocker arm assembly, then disassemble the rocker arm.
Put the rocker shaft holder bridge on the cylinder head, then tight ...
Front Seat Frame Replacement
Driver's Seat
Check the operation of the driver's seat position sensor after
any of these actions :
Driver's seat position sensor replacement
Cover plate (f ...
Door Glass Adjustment
NOTE: Check the weatherstrips and glass run channel for damage or deterioration,
and replace them if necessary.
Place the vehicle on a firm, level surface.
Remove these items:
...
Categories
