Honda Fit manuals

Honda Fit: Suspension Ball Joints

See also:

Secondary Shaft 2nd Gear Axial Clearance Inspection (A/T)
Install the thrust needle bearing (A), the needle bearing (B), 2nd gear (C), the thrust needle bearing (D), the 43 x 54.5 mm thrust washer (E), the 39 mm cotters (F), and the cotter retain ...

EPS Control Unit Removal/Installation
Do the battery terminal disconnection procedure. Remove the under-dash fuse/relay box. Disconnect EPS control unit connector A (11P) and connector B (16P) by pus ...

Alternator Disassembly (Page -3)
Install a new front bearing in the drive-end housing with a hammer, the driver handle, 15 x 135L (A), and the bearing driver attachment, 42 x 47 mm (B). @fo ...

© 2026 Copyright www.hfitinfo.com