Special Tools Required
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
Put on gloves to protect your hands.
Take care not to bend or scratch the trim and panels.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
Release the hooks (A), then pull up the cargo floor (B) and remove it.
Without spare tire
With spare tire
Release the bungee (C).
Remove the tailgate weatherstrip, as needed.
With temporary repair kit (TRK): Remove the cargo floor box (A)
Remove the rear trim panel (A).
Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).
Detach the clips by pulling the panel up.
Install the trim in the reverse order of removal, and note these items:
If the clips are damaged or stress-whitened, replace them with new ones.
Push the clips, the hooks, and the tabs into place securely.
Engine Does Not Start
Checking the Engine
If the engine does not start, turn the ignition switch to START
and check the
starter.
If you must start the vehicle immediately, use an
assisting vehicle to jump start it. ...
MAF Sensor/IAT Sensor Replacement
Disconnect the MAF sensor/IAT sensor connector (A).
Remove the screws (B).
Remove the MAF sensor/IAT sensor (C).
Install the parts in the reverse order of removal ...
A/T Clutch Pressure Control Solenoid Valve B and C Replacement (A/T)
Remove the air cleaner assembly.
Remove the breather hose (A) from its clamp (B), and remove the breather
hose clamp bracket (C).
Disconnect the connectors (A) ...