Honda Fit: Interior Trim Removal/Installation - Cargo Area
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Release the hooks (A), then pull up the cargo floor (B) and remove it.
Without spare tire
With spare tire
-
Release the bungee (C).
-
Remove the tailgate weatherstrip, as needed.
-
With temporary repair kit (TRK): Remove the cargo floor box (A)
-
Remove the rear trim panel (A).
-
Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).
-
Detach the clips by pulling the panel up.
-
-
Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips, the hooks, and the tabs into place securely.
-
See also:
Displaying the Map Menu
Use the Map Menu to control the icons displayed on the screen. You can also
use
the Map Menu to find locations or to cancel the route.
1. On the map screen, select MAP
MENU (if displayed).
...
Windshield Replacement
NOTE:
Put on gloves to protect your hands.
Wear eye protection while cutting the glass adhesive with a piano wire.
Use seat covers to avoid damaging any surface.
Glass a ...
Throttle Body Cleaning
caution
Do not insert your fingers into the installed throttle body when you
turn the ignition switch to ON (II) or while the ignition switch is in
ON (II). If you d ...
Categories
