Honda Fit: Interior Trim Removal/Installation - Cargo Area
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Release the hooks (A), then pull up the cargo floor (B) and remove it.
Without spare tire
With spare tire
-
Release the bungee (C).
-
Remove the tailgate weatherstrip, as needed.
-
With temporary repair kit (TRK): Remove the cargo floor box (A)
-
Remove the rear trim panel (A).
-
Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).
-
Detach the clips by pulling the panel up.
-
-
Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips, the hooks, and the tabs into place securely.
-
See also:
Fuel Information
■ Fuel recomme
Unleaded gasoline, pump octane number 87 or higher
Use of lower octane gasoline can cause a persistent, heavy metallic knocking
noise
that can lead to engine damage.
■ ...
Seats
Front Seat Adjustments
Make all seat adjustments before you start driving.
To adjust the seat forward and backward, pull up on the lever under the seat
cushion’s front edge. Move the seat to t ...
Transmission End Cover ATF Feed Pipe Replacement (A/T)
Remove the snap ring (A), the 3rd clutch feed pipe (B), and the feed pipe
flange (C) from the end cover (D).
Install a new O-ring (E) over the 3rd clutch feed pipe.
In ...
Categories
