Honda Fit: Interior Trim Removal/Installation - Cargo Area
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Release the hooks (A), then pull up the cargo floor (B) and remove it.
Without spare tire
With spare tire
-
Release the bungee (C).
-
Remove the tailgate weatherstrip, as needed.
-
With temporary repair kit (TRK): Remove the cargo floor box (A)
-
Remove the rear trim panel (A).
-
Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).
-
Detach the clips by pulling the panel up.
-
-
Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips, the hooks, and the tabs into place securely.
-
See also:
M/T Differential Thrust Clearance Adjustment (M/T)
Special Tools Required
Driver Handle, 40 mm I.D. 07746-0030100
Remove the left driveshaft side oil seal from the transmission housing.
If you remove the 80 mm shim (A) fro ...
Clutch Clearance Inspection (A/T)
Special Tools Required
Clutch Compressor Attachment 07ZAE-PRP0100
Inspect the clutch piston, the discs, the plates, and the end-plate for
wear and damage, and inspect the clutch wav ...
Emergency Towing
Call a professional towing service if you need to tow your vehicle.
■ Flat bed equipment
The operator loads your vehicle on the back of a truck.
This is the best way to transport your veh ...
Categories
