Honda Fit: Interior Trim Removal/Installation - Cargo Area
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Release the hooks (A), then pull up the cargo floor (B) and remove it.
Without spare tire
With spare tire
-
Release the bungee (C).
-
Remove the tailgate weatherstrip, as needed.
-
With temporary repair kit (TRK): Remove the cargo floor box (A)
-
Remove the rear trim panel (A).
-
Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).
-
Detach the clips by pulling the panel up.
-
-
Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips, the hooks, and the tabs into place securely.
-
See also:
Voice Control Operation
1 Press and release the (Talk)
button.
A helpful prompt asks what you
would like to do. Press and release
the (Talk) button again to bypass
this prompt.
► The icon is displayed and ...
Engine Oil Filter Feed Pipe Replacement
Remove the filter.
Remove the oil filter feed pipe.
Install two 20 x 1.5 mm nuts (A) onto the new oil filter feed pipe, and
hold one nut with a wrench, then ti ...
Park Pin Switch Replacement (A/T)
NOTE: The park pin switch is installed in the shift lever bracket base, and
not available separately from the shift lever bracket base; replace the park pin
switch and the shift lever bracket base ...
Categories
