Honda Fit: Interior Trim Removal/Installation - Cargo Area
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Release the hooks (A), then pull up the cargo floor (B) and remove it.
Without spare tire
With spare tire
-
Release the bungee (C).
-
Remove the tailgate weatherstrip, as needed.
-
With temporary repair kit (TRK): Remove the cargo floor box (A)
-
Remove the rear trim panel (A).
-
Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).
-
Detach the clips by pulling the panel up.
-
-
Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips, the hooks, and the tabs into place securely.
-
See also:
Secondary HO2S Replacement
Special Tools Required
O2 Sensor Wrench Snap-on S6176 or equivalent, commercially available
Disconnect the secondary HO2S connector (A).
Raise the vehicle on a lift.
...
Front Individual Map Light Test/Replacement (With Navigation)
With navigation
Turn the individual map light switch OFF.
Carefully pry the lens (A) off with a small screwdriver.
Individual Map Light:
8 ...
Wheels
Clean the wheels as you would the rest of the exterior. Wash them with the same
solution, and rinse them thoroughly.
If equipped
Aluminum alloy wheels have a protective clear-coat that keeps the a ...
Categories
