Honda Fit: Interior Trim Removal/Installation - Cargo Area
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Release the hooks (A), then pull up the cargo floor (B) and remove it.
Without spare tire
With spare tire
-
Release the bungee (C).
-
Remove the tailgate weatherstrip, as needed.
-
With temporary repair kit (TRK): Remove the cargo floor box (A)
-
Remove the rear trim panel (A).
-
Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).
-
Detach the clips by pulling the panel up.
-
-
Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips, the hooks, and the tabs into place securely.
-
See also:
System Theft Protection
The system is disabled when it is disconnected from the power source, such as
when
the battery is disconnected or goes dead.
■ Reactivating the system
1. Turn the ignition switch to ON (II) ...
Synchro Ring and Gear Inspection (M/T)
Inspect the synchro rings for scoring, cracks, and damage (A).
Inspect the inside of each synchro ring (B) for wear. Inspect the teeth
(C) on each synchro ring for wear (round ...
Auto Door Locking/Unlocking
Your vehicle locks all doors and unlocks the driver’s door automatically when
a
certain condition is met.
You can turn off or change to another auto door
locking/unlocking setting using the mas ...
Categories
