Honda Fit: Tailgate Lock Cylinder Replacement
For Some Models
NOTE: Put on gloves to protect your hands.
-
Remove the tailgate lower trim panal.
-
Disconnect the tailgate cylinder rod (A).
NOTE: Check for damaged or stress-whitened rod fastener (B).
-
Remove the bolts securing the lock cylinder (A), then remove the lock cylinder by turning it.
-
Install the lock cylinder in the reverse order of removal, and note these items:
-
Make sure the cylinder rod is connected properly.
-
Make sure the tailgate opens properly and locks securely.
-
See also:
A/T Housing Idler Gear Shaft Removal and Installation (A/T)
Remove the snap ring (A), the cotter retainer (B), and the cotters (C)
from the idler gear shaft (D), then remove the idler gear shaft. Do not
distort the snap ring.
Check ...
Instruments and Controls
This section gives information about the controls and displays that contribute
to the daily operation of your vehicle. All the essential controls are within easy
reach. ...
Engine Does Not Start
Checking the Engine
If the engine does not start, turn the ignition switch to START
and check the
starter.
If you must start the vehicle immediately, use an
assisting vehicle to jump start it. ...
Categories
