HandsFreeLink Control Unit 32P Connector
|
Cavity |
Wire Color |
Connects to |
|
1 |
BLK |
Body ground to G501 (GND) |
|
2 |
GRN |
HFL-navigation voice control switch (STRG SW) |
|
4 |
YEL |
Audio-navigation unit (GA-NET BUS+) |
|
5 |
GRN |
Audio-navigation unit (GA-NET BUS-) |
|
11 |
BLK |
Audio-navigation unit (AUDIO R+) |
|
12 |
WHT |
Audio-navigation unit (AUDIO L+) |
|
13 |
PNK |
Audio-navigation unit (TELEM SIG+) |
|
14 |
GRY* |
Shield for terminals No. 15 and No. 16 (MIC SH) |
|
15 |
LT GRN |
HFL-navigation microphone (MIC SIG) |
|
16 |
PUR |
HFL-navigation microphone (MIC GND) |
|
17 |
PNK |
No. 1 (10 A) fuse in the under-dash fuse/relay box (+B) |
|
18 |
ORN |
No. 14 (7.5 A) fuse in the under-dash fuse/relay box (ACC) |
|
21 |
GRY* |
Shield for terminals No. 4 and No. 5 (GA-NET BUS SH) |
|
26 |
GRY* |
Shield for terminals No. 11, No. 12, No. 27, and No. 28 (AUDIO SH) |
|
27 |
RED |
Audio-navigation unit (AUDIO R-) |
|
28 |
GRN |
Audio-navigation unit (AUDIO L-) |
|
29 |
BLU |
Audio-navigation unit (TELEM SIG-) |
|
30 |
GRY* |
Shield for terminals No. 13 and No. 29 (TELEM SIG SIG) |
|
31 |
YEL |
Audio-navigation unit (HFT-NAVI MIC+) |
|
32 |
GRN |
Audio-navigation unit (HFT-NAVI MIC-) |
|
*: |
The shielded wires have a heat-shrink tube insulating the outside of the wire. The color of the insulating tube, typically black or dark gray, may not match the color of the wire shown on the circuit diagram. |
HandsFreeLink Control Unit Connector for Inputs and Outputs
Transmission End Cover Selector Control Shaft Oil Seal Replacement (A/T)
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Bearing Driver Attachment, 22 x 24 mm 07746-0010800
Remove the oil seal from the end cover.
Install the new oil ...
Interior Lights
Ceiling Light
The ceiling light has a three-position switch; ON, Door Activated, and OFF. In
the Door Activated (center) position, the light comes on when you:
• Open any door.
• Unlock the ...
A/T Differential Backlash Inspection (A/T)
Install the driveshaft and intermediate shaft into the differential
assembly, and place the axles on V-blocks (A).
Measure the backlash of the pinion gears (B) wit ...