Honda Fit manuals

Honda Fit: Dust and Pollen Filter

On models with A/C

This filter removes the dust and pollen that is brought in fromthe outside through the heating and cooling system.

Have your dealer replace the filter when this service is indicated by a maintenance message on the information display. It should be replaced every 15,000 miles (24,000 km) if you drive primarily in urban areas that have high concentrations of soot in the air, or if the flow from the heating and cooling system becomes less than usual.

See also:

Steering Rack Guide Adjustment
Special Tools Required Locknut Wrench, 40 mm 07MAA-SL00100, 07916-SA50001, or 07AAA-TL2A100 Set the wheels in the straight ahead position. Loosen the rack guide screw locknut ...

Secondary Shaft 2nd Gear Axial Clearance Inspection (A/T)
Install the thrust needle bearing (A), the needle bearing (B), 2nd gear (C), the thrust needle bearing (D), the 43 x 54.5 mm thrust washer (E), the 39 mm cotters (F), and the cotter retain ...

Clutch Clearance Inspection (A/T)
Special Tools Required Clutch Compressor Attachment 07ZAE-PRP0100 Inspect the clutch piston, the discs, the plates, and the end-plate for wear and damage, and inspect the clutch wav ...

© 2026 Copyright www.hfitinfo.com