Honda Fit: Display, Accessories

See also:

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Inspecting and Changing Fuses
1. Turn the ignition switch to LOCK . Turn headlights and all accessories off. 2. Check the fuses in the engine compartment. ► If the fuse is blown, have it replaced by a dealer. 3. I ...

M/T Differential Backlash Inspection (M/T)
Place the differential assembly on V-blocks (A), and install the right driveshaft (B) and the left driveshaft (C). Measure the backlash of both pinion gears (D) with a dial in ...