Honda Fit: Engine Does Not Start
Checking the Engine
If the engine does not start, turn the ignition switch to START
and check the
starter.
If you must start the vehicle immediately, use an assisting vehicle to jump start it.
See also:
Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque
its locknut to 110 N·m (11.2 kgf·m, 81 lbf·ft).
Remove any grease or any oil from the ...
ATF Replacement (A/T)
NOTE: Keep all foreign particles out of the transmission.
Warm up the engine to normal operating temperature (the radiator fan
comes on), and turn the engine off.
Raise the vehic ...
Paddle Shifter (Downshift Switch) Replacement (A/T)
SRS components are located in this area. Review the SRS component locations
and the precautions and procedures before doing repairs or service.
Remove the steering ...
Categories
