Honda Fit: ATF Lines

See also:

Rotor Slip Ring Test
Measure the resistance between the slip rings (A): If the resistance is within the standard, go to step 22. If the resistance is not within the standard, replace the roto ...

Drive Belt Auto-Tensioner Inspection
Turn the ignition switch to ON (II), and make sure to turn the A/C switch OFF, then turn the ignition switch to LOCK (0). Check the position of the auto-tensioner indicator (A). S ...

Pressure Plate Inspection and Removal
Remove the transmission. Check the evenness of the height of the diaphragm spring fingers using the clutch alignment disc (A), clutch alignment shaft (B), remover handle (C ...