Honda Fit manuals

Honda Fit: Ignition Coil and Spark Plug Removal/Installation

  1. Remove the under-cowl panel.

  1. Disconnect the ignition coil connectors (A), then remove the ignition coils (B).

  1. Remove the spark plugs, and inspect them.

  2. Apply a small amount of anti-seize compound to the plug threads, and screw the plugs into the cylinder head, finger tight, then tighten the plugs to the specified torque.

    Specified Torque

    18 NВ·m (1.8 kgfВ·m, 13 lbfВ·ft)

  3. Install all remaining parts in the reverse order of removal.

See also:

Edit Waypoint Search Area
INFO button ► Setup ►Other ►Routing & Guidance►Edit Waypoint Search Area “Edit” Select the distance from your highlighted route line (on either side of your rout ...

Output Shaft (Countershaft) Speed Sensor Replacement (M/T)
M/T Raise the vehicle on a lift. Disconnect the output shaft (countershaft) speed sensor connector (A). Remove the output shaft (countershaft) speed sensor (B). ...

Reporting Safety Defects (U.S. Vehicles)
If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in ...

© 2026 Copyright www.hfitinfo.com