Honda Fit: Ignition System

See also:

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Ball Joint Removal
Special Tools Required Ball Joint Thread Protector, 10 mm 07AAF-SECA120 Ball Joint Thread Protector, 14 mm 071AF-S3VA000 Ball Joint Remover, 28 mm 07MAC-SL0A202 notice ...

Countershaft Disassembly (M/T)
NOTE: Refer to the Exploded View in the countershaft reassembly, as needed, when removing components pressed onto the countershaft. Securely clamp the countershaft assembly in a bench vise wi ...