Honda Fit manuals

Honda Fit: Driveshafts

See also:

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Transmission Side - Release Bearing Inspection
Check the play of the release bearing by spinning it by hand. If there is excessive play or noise, replace the release bearing. NOTE: The release bearing is packed with grease. Do not ...

Heater Unit - Core Replacement Part-1
SRS components are located in this area. Review the SRS component locations   and the precautions and procedures   before doing repairs or service. Do the battery t ...

© 2025 Copyright www.hfitinfo.com