NOTE: Install the receiver/dryer as quickly as possible to prevent the system from absorbing moisture from the air.
Remove the A/C condenser.
Remove the bolts from the A/C condenser, then remove the receiver/dryer (A), the bracket (B), and the O-rings (C).
Install the receiver/dryer in the reverse order of removal. Replace the O-rings with new ones, and apply a thin coat of refrigerant oil (SP-10) before installing them. Be sure to use the correct O-rings for HFC-134a (R-134a) to avoid leakage.
Braking System
Your vehicle is equipped with front disc brakes. The brakes on the rear wheels
are drum. A power assist helps reduce the effort needed on the brake pedal. The
anti-lock brake system (ABS) helps yo ...
Water Pump Inspection
Remove the right front wheel.
Remove the splash shield.
Loosen the water pump pulley mounting bolts (A).
Remove the drive belt.
Remove the ...
Pilot Bearing Replacement
Remove the crankshaft pilot bearing (A) using the remover weight (B), and
the 15 mm bearing remover shaft set (C).
Install a new pilot bearing (A) into the crankshaft using th ...