Honda Fit: Restraints

See also:

Alternator Brush Inspection
Measure the length of both brushes (A) with a vernier caliper: If either brush is shorter than the service limit, replace the brushes, go to step 20. If brush length ...

Secondary HO2S Replacement
Special Tools Required O2 Sensor Wrench Snap-on S6176 or equivalent, commercially available Disconnect the secondary HO2S connector (A). Raise the vehicle on a lift. ...

Removal
NOTE: Do not allow dust, dirt, or other foreign materials to enter the steering gearbox. Remove the steering gearbox. Remove both tie-rod ends from the rack ends. R ...