NOTE: Take care not to scratch the door or related parts.
Remove the door sash outer trim (A).
Remove the screw from inside the door.
Release the lower edge of the trim from the door glass outer weatherstrip (B).
Pull the trim up to release the hooks (C) from the door, then remove the trim.
Install the trim in the reverse order of removal.
Make sure that there is no clearance between the rear edge of the door glass outer weatherstrip and the trim.
How to Use This Manual
This section explains different methods on how you can easily find
information in this manual.
Searching the Table of Contents
Two types of Tables of Contents help
you find your desired informati ...
EPS Motor Removal and Installation
NOTE: Do not allow dust, dirt, or other foreign materials to enter the
steering gearbox.
Removal
Remove the steering gearbox.
Remove the EPS motor 3P connector (A) and the EPS ...
A/T Housing Idler Gear Shaft Removal and Installation (A/T)
Remove the snap ring (A), the cotter retainer (B), and the cotters (C)
from the idler gear shaft (D), then remove the idler gear shaft. Do not
distort the snap ring.
Check ...