Replace your tires with radials of the same size, load range, speed rating, and maximum cold tire pressure rating (as shown on the tire’s sidewall). Using tires of a different size or construction can cause the ABS and VSA® (vehicle stability assist) system to work incorrectly.
It is best to replace all four tires at the same time. If that isn’t possible, replace the front or rear tires in pairs.
Make sure that the wheel’s specifications match those of the original wheels.
U.S. models only
If you replace a wheel, only use TPMS specified wheels approved for your vehicl
WARNING
Installing improper tires on your vehicle can
affect handling and stability. This can cause
a crash in which you can be seriously hurt or
killed.
Always use the size and type of tires recommended in this owner’s manual.
Secondary Shaft 2nd Gear Axial Clearance Inspection (A/T)
Install the thrust needle bearing (A), the needle bearing (B), 2nd gear
(C), the thrust needle bearing (D), the 43 x 54.5 mm thrust washer (E), the
39 mm cotters (F), and the cotter retain ...
Rerouting
INFO button
► Setup ►Other
►Routing & Guidance
Set whether route recalculation occurs automatically or manually during route
guidance.
Select an option.
The following op ...
Front Lower Arm Removal/Installation
Special Tools Required
Ball Joint Thread Protector, 14 mm 071AF-S3VA000
Ball Joint Remover, 28 mm 07MAC-SL0A202
notice
Do not remove the lower arm from both sides a ...