Honda Fit: Maintenance

See also:

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Pilot Bearing Inspection
Inspect the crankshaft pilot bearing for wear and damage. Inspect the inside surface of the crankshaft pilot bearing with your finger. If the crankshaft pilot bearing is not smoot ...

VSA Off Switch Test/Replacement
NOTE: If the low tire pressure indicator turns ON, the VSA cannot be turned OFF. Check the tire pressure first. Turn the ignition switch to LOCK (0). Remove the driver's da ...