Honda Fit: Shift Lever Housing Replacement (M/T)
NOTE: Take care not to scratch the center console, dashboard, and related parts.
-
Remove the center console.
-
Remove the harness clamps (A).
-
Remove the lock pin (A), the washer (B), the shift cable clip (C), and the shift cables (D) from the shift lever housing assembly (E).
-
Remove the four bolts (A). Disconnect the shift cables (B) from the shift lever, then remove the shift lever housing (C).
-
Install the shift lever housing in the reverse order of removal.
See also:
A/T Differential Carrier Bearing Preload Inspection (A/T)
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Bearing Driver Attachment, 72 x 75 mm 07746-0010600
Preload Inspection Tool 07HAJ-PK40201
NOTE: If the transmission housing, torq ...
A/T Differential Backlash Inspection (A/T)
Install the driveshaft and intermediate shaft into the differential
assembly, and place the axles on V-blocks (A).
Measure the backlash of the pinion gears (B) wit ...
Engine Compression Inspection
NOTE: After the inspection, you must reset the ECM/PCM. Otherwise, the
ECM/PCM will continue to stop the injectors from operating.
Allow the engine to reach operating temperature (fan comes o ...
Categories
