Secondary Shaft Disassembly, Inspection, and Reassembly (A/T)
Inspect the thrust needle bearings and the needle bearings for galling
and rough movement.
Inspect the splines for excessive wear and damage.
Check the shaft bearing s ...
Change Lever Clearance Inspection (M/T)
Measure the clearance between the change lever (A) and the select lever
(B) with a feeler gauge (C). If the clearance is more than the service
limit, go to step 2.
...
Resuming Your Trip
Stop your vehicle en route (e.g., to rest, stop for gas, etc.), and then
continue on
your route.
If you did not complete your route, the Continue Trip screen is displayed when
you
restart you ...