Honda Fit manuals

Honda Fit: M/T Differential Backlash Inspection (M/T)

  1. Place the differential assembly on V-blocks (A), and install the right driveshaft (B) and the left driveshaft (C).

  1. Measure the backlash of both pinion gears (D) with a dial indicator (E). If the backlash is not within the standard, replace the differential carrier.

    Standard (New):

    0.05пјЌ0.15 mm (0.0020пјЌ0.0059 in)

See also:

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Break-in Period
Help assure your vehicle’s future reliability and performance by paying extra attention to how you drive during the first 600 miles (1,000 km). During this period: • Avoid full-throttle starts ...

Output Shaft (Countershaft) Speed Sensor Replacement (M/T)
M/T Raise the vehicle on a lift. Disconnect the output shaft (countershaft) speed sensor connector (A). Remove the output shaft (countershaft) speed sensor (B). ...

© 2026 Copyright www.hfitinfo.com