Honda Fit: Front Stabilizer Bar Replacement
Removal
-
Remove the front subframe.
-
Remove the steering gearbox from the front subframe.
-
Remove the flange bolts (A) and the bushing holders (B), then remove the bushings (C).
-
Remove the stabilizer bar (D) from the front subframe.
-
Installation
-
Install the bushings (A) on the stabilizer bar.
NOTE:
-
Note the direction of installation for the bushings.
-
Align the stabilizer band clamp (B) with the side of the bushings.
-
-
Install the stabilizer bar (A) with the bushings on the front subframe.
NOTE:
-
Note the right and left direction of the stabilizer bar.
-
Note the direction of installation for the bushing holders (B).
-
-
Install the steering gearbox on the front subframe.
-
Install the front subframe.
See also:
Audio Remote Controls
Steering Wheel Controls
Control basic audio system functions using the controls mounted on the
steering
wheel.
■MODE Button
Cycles through the audio modes as follows:
DISC mode appear ...
Canceling the Route
DEST button (when en route)
►Cancel Route
Cancel the route guidance and remove the destination and all waypoints from
the
destination list. The system then returns to the map screen.
You ...
Reverse Shift Fork Clearance Inspection (M/T)
Measure the clearance between the reverse idler gear (A) and the reverse
shift fork (B) with a feeler gauge (C). If the clearance is more than the
service limit, go to step 2.
...
Categories
