Special Tools Required
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
Put on gloves to protect your hands.
Take care not to bend or scratch the trim and panels.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
Release the hooks (A), then pull up the cargo floor (B) and remove it.
Without spare tire
With spare tire
Release the bungee (C).
Remove the tailgate weatherstrip, as needed.
With temporary repair kit (TRK): Remove the cargo floor box (A)
Remove the rear trim panel (A).
Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).
Detach the clips by pulling the panel up.
Install the trim in the reverse order of removal, and note these items:
If the clips are damaged or stress-whitened, replace them with new ones.
Push the clips, the hooks, and the tabs into place securely.
Secondary Shaft Disassembly, Inspection, and Reassembly (A/T)
Inspect the thrust needle bearings and the needle bearings for galling
and rough movement.
Inspect the splines for excessive wear and damage.
Check the shaft bearing s ...
Other Features
This section describes the useful functions incorporated into the
navigation system. ...
Locking/Unlocking the Doors from the Outside
Using the Remote Transmitter*
■ Locking the doors
Press the lock button.
Once:
►Some exterior lights flash, all the doors
and tailgate lock, and the security system
sets.
Twic ...