Honda Fit: Interior Trim Removal/Installation - Cargo Area
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Release the hooks (A), then pull up the cargo floor (B) and remove it.
Without spare tire
With spare tire
-
Release the bungee (C).
-
Remove the tailgate weatherstrip, as needed.
-
With temporary repair kit (TRK): Remove the cargo floor box (A)
-
Remove the rear trim panel (A).
-
Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).
-
Detach the clips by pulling the panel up.
-
-
Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips, the hooks, and the tabs into place securely.
-
See also:
Playing a Disc
To Play a CD
All models except Sp
To load or play CDs, the ignition switch must be in the ACCESSORY (I) or the
ON(II) position.
You operate the CD player with the same controls used for the rad ...
Steering Angle Sensor Replacement
SRS components are located in this area. Review the
SRS component locations and the
precautions and procedures.
NOTE: Do not damage or drop the combination switch as the steering angle ...
FTP Sensor Replacement
Remove the EVAP canister.
Disconnect the FTP sensor connector (A).
Disconnect the hose (B), remove the retainer (C), and remove the FTP
sensor (D).
Ins ...
Categories
