Honda Fit: Interior Trim Removal/Installation - Cargo Area
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Release the hooks (A), then pull up the cargo floor (B) and remove it.
Without spare tire
With spare tire
-
Release the bungee (C).
-
Remove the tailgate weatherstrip, as needed.
-
With temporary repair kit (TRK): Remove the cargo floor box (A)
-
Remove the rear trim panel (A).
-
Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).
-
Detach the clips by pulling the panel up.
-
-
Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips, the hooks, and the tabs into place securely.
-
See also:
Driveshaft Removal
Special Tools Required
Ball Joint Remover, 28 mm 07MAC-SL0A202
Ball Joint Thread Protector, 14 mm 071AF-S3VA000
Raise and support the vehicle.
Remove the front wheel.
...
M/T Differential Backlash Inspection (M/T)
Place the differential assembly on V-blocks (A), and install the right
driveshaft (B) and the left driveshaft (C).
Measure the backlash of both pinion gears (D) with a dial in ...
Playing the AM/FM Radio
To Play the AM/FMRadio
The ignition switch must be in the ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the PWR/VOL knob or the AM/FM button (AM or FM
button except Sport mode ...
Categories
