Honda Fit: Interior Trim Removal/Installation - Cargo Area
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Release the hooks (A), then pull up the cargo floor (B) and remove it.
Without spare tire
With spare tire
-
Release the bungee (C).
-
Remove the tailgate weatherstrip, as needed.
-
With temporary repair kit (TRK): Remove the cargo floor box (A)
-
Remove the rear trim panel (A).
-
Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).
-
Detach the clips by pulling the panel up.
-
-
Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips, the hooks, and the tabs into place securely.
-
See also:
Transmission Side - Release Bearing Removal
Remove the transmission.
Remove the release fork boot (A) from the clutch housing (B).
Squeeze the release fork set spring (C) with pliers to remove the release
...
Installation
Hold the gearbox housing using a C-clamp (A) and wooden blocks (B) to a
workbench as shown. Do not clamp the cylinder part of the gearbox housing in
a vise.
...
Compatible iPod® and USB Flash Drives
iPod® Model Compatibility
This system may not work with all software versions
of these devices.
USB Flash Drives
• Use a recommended USB flash drive of 256 MB or higher.
• Some digital aud ...
Categories
