Honda Fit: Interior Trim Removal/Installation - Cargo Area
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Release the hooks (A), then pull up the cargo floor (B) and remove it.
Without spare tire
With spare tire
-
Release the bungee (C).
-
Remove the tailgate weatherstrip, as needed.
-
With temporary repair kit (TRK): Remove the cargo floor box (A)
-
Remove the rear trim panel (A).
-
Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).
-
Detach the clips by pulling the panel up.
-
-
Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips, the hooks, and the tabs into place securely.
-
See also:
Front Passenger's Weight Sensor Replacement (Part-1)
Removal
NOTE: .
Removal of the front passenger's weight sensors must be
done according to precautions and procedures.
The front passenger's weight sensor are part of the ...
Splash Shield Replacement
NOTE:
Put on gloves to protect your hands.
Take care not to scratch the body.
Remove the splash shield (A).
From the wheel arch on both sides, remove the clips (B) ...
Using the Tailgate Open Handle
Models with remote transmitter
When all the doors are unlocked, the tailgate
is unlocked.
All models
Pull up the tailgate open handle and lift open
the tailgate.
To close the tailgate, grab ...
Categories
