Honda Fit manuals

Honda Fit: Transmission End Crankshaft Oil Seal Installation - In Car

Second generation (2007-2026) / Honda Fit 2007-2026 Repair Manual / Powertrain / Engine / Engine Block / Transmission End Crankshaft Oil Seal Installation - In Car

Special Tools Required

  1. Remove the transmission.

    • M/T model

    • A/T model

  1. M/T model: Remove the pressure plate, the clutch disc, and the flywheel.

  1. A/T model: Remove the drive plate.

  1. Clean and dry the crankshaft oil seal housing.

  1. Apply a light coat of new engine oil to the lip of the crankshaft oil seal.

  1. Using the driver handle, 15 x 135 L (A), and the oil seal driver attachment, 96 mm (B), to drive a new crankshaft oil seal squarely into the engine block to the specified installed height.

  1. Measure the distance between the cylinder block (A) and the crankshaft oil seal (B).

    Oil Seal Installed Height

    0.2пјЌ1.2 mm (0.008пјЌ0.047 in)

  1. M/T model: Install the flywheel, the clutch disc, and the pressure plate.

  2. A/T model: Install the drive plate.

  3. Install the transmission.

    • M/T model

    • A/T model

See also:

Front Seat-Back Cover/Pad Replacement (Part - 2)
Release airbag attachment wire A and airbag attachment wire B from the seat-back frame (C). @font-face{font-family: "Honda_SymbolMarkeng";src:url(/statics ...

Transmission End Cover Removal (A/T)
Special Tools Required Mainshaft Holder 07GAB-PF50101 Remove the bolts securing the ATF inlet line (D) and ATF filter holder (E), the line bolt and sealing washers, and remove the ATF in ...

EVAP Canister Vent Shut Valve Replacement
Remove the EVAP canister assembly. Remove the hose (A), and disconnect the EVAP canister vent shut valve connector (B). Remove the EVAP canister vent shut valv ...

© 2026 Copyright www.hfitinfo.com