Honda Fit: Heater Unit - Core Replacement Part-2
-
Remove the drain hose (A), then remove the mounting nuts and the blower-heater unit (B).
-
Remove the self-tapping screws and the heater core cover (A).
See also:
Regulator Valve Body Disassembly, Inspection, and Reassembly (A/T)
Clean all parts thoroughly in solvent, and dry them with compressed air.
Blow out all passages except the air check valve filter.
Inspect the regulator valve body for scoring and ...
ODS Unit Replacement
Removal
Do the battery terminal disconnection procedure,
then wait at least 3 minutes before starting work.
Disconnect the passenger's side airbag harness 2P connector. ...
Intermediate Shaft Reassembly (A/T)
Exploded View
Special Tools Required
Oil Seal Driver, 65 mm 07JAD-PL90100
Bearing Driver Attachment, 52 x 55 mm 07746-0010400
Bearing Driver Attachment, 35 mm I.D. 07746-0030400
Drive ...
Categories
