Honda Fit manuals

Honda Fit: Exploded View

FRONT BEARINGRETAINERFRONT BEARINGPULLEYDRIVE-END HOUSINGSTATORREAR BEARINGSPACERTERMINALINSULATORRECTIFIERVOLTAGE REGULATOR/BRUSH HOLDER ASSEMBLYREAR HOUSINGROTOR110 N·m (11.2kgf·m, 81 lbf·ft)

Special Tools Required

NOTE: Refer to the Exploded View if needed during this procedure.

  1. Test the alternator and regulator before you remove them.

  1. Remove the alternator.

See also:

Clutch Replacement (M/T)
Special Tools Required Clutch Alignment Disc 07JAF-PM7011A Clutch Alignment Shaft 07JAF-PM7012A Clutch Alignment Shaft 07ZAF-PR8A100 Ring Gear Holder 07LAB-PV00100 Weight, Remover 07741-0010 ...

Secondary Shaft 2nd Gear Axial Clearance Inspection (A/T)
Install the thrust needle bearing (A), the needle bearing (B), 2nd gear (C), the thrust needle bearing (D), the 43 x 54.5 mm thrust washer (E), the 39 mm cotters (F), and the cotter retain ...

Engine Compression Inspection
NOTE: After the inspection, you must reset the ECM/PCM. Otherwise, the ECM/PCM will continue to stop the injectors from operating. Allow the engine to reach operating temperature (fan comes o ...

© 2026 Copyright www.hfitinfo.com