Honda Fit manuals

Honda Fit: Installation (Part -1)

Second generation (2007-2026) / Honda Fit 2007-2026 Repair Manual / Chassis / Steering / Steering Gear Assembly / Steering Gearbox Removal and Installation / Installation (Part -1)

  1. Before installing the steering gearbox, make sure that no grease is on the mating surface of the steering gearbox and the front subframe. To prevent the gearbox mounting bolts from loosening after the installation, remove any grease from the bolt holes.

  1. Install the pinion shaft grommet (A). Align the lug portion (B) in the pinion shaft grommet to the steering gearbox.

    2. AB

  1. Place the steering gearbox (A) on the front subframe (B).

    2. AB?10 x 1.25 mm60 NВ·m (6.1 kgfВ·m, 44 lbfВ·ft)Replace.?10 x 1.25 mm60 NВ·m(6.1 kgfВ·m, 44 lbfВ·ft)Replace.?10 x 1.25 mm59 NВ·m(6.0 kgfВ·m, 43 lbfВ·ft)Replace.?10 x 1.25 mm60 NВ·m(6.1 kgfВ·m, 44 lbfВ·ft)Replace.?10 x 1.25 mm59 NВ·m(6.0 kgfВ·m, 43 lbfВ·ft)Replace.C

  2. Loosely install the stiffener plates (C), and new gearbox mounting bolts, then tighten the bolts to the specified torque in the sequence shown.

  3. Turn the lip of the pinion shaft grommet to ease installation.

See also:

Exploded View
@font-face{font-family: "Honda_SymbolMarkeng";src:url(/statics/ho_prod_2/txt/Honda_SymbolMark_enu3.txt);}@font-face{font-family: "Honda_Special_Symbols";src:url(/sta ...

Shift Cable Adjustment (A/T)
Remove the center console. Shift the transmission to N. Remove the nut securing the shift cable end. Rotate the socket holder (A) on the shift cable ( ...

Removal (Part -2)
Remove the harness clamp (A) from its clamp bracket (B) located in front of the left damper top. @font-face{font-family: "Honda_SymbolMarkeng";src:url(/st ...

Categories

© 2026 Copyright www.hfitinfo.com